Quote:
Originally Posted by baddlord777
Nope...same issue..nothing has changed..when you go into the arc software.....software communicates fine with radio ref. just fine and can find frequencies and all. But when i attempt to send data, or receive from scanner...or detect scanner/auto detect...finds nothing...The virtual was just a test to see if i could control the scanner manually inside virtual...which i can.
Updated firmware no problem...so i know the computer is talking to the scanner.......but software does not seem to be.
Is there a local us# i can call for Butel help ?
Does anyone know if in device manager for port assign if:
Flow Control
Stop Bits
parity
data bits
Fifo buffers
rec. buffer 1-14
transmit buffer 1-16 if any of these would need to be changed.....i un-installed and re-installed software....did not change a thing..auto-detect just will not communicate with scanner
|
OK It seemed like in your first post it would not communicate at all, then you indicated the VC was working but upload/dowload was not, that's pretty much changing horses in mid-stream. At any rate, I have never had to change any of the comm port settings like you ask about above. It just does not seem to be any type of hardware issue since you said you can VC and do FW update, obvioulsy the port is working. Has to be software. Try downloading it again and do another install. For Butel, go to the ARC996 Yahoo Group, Gommert should be there lurking, he is the Butel rep. He is here sometimes but more consistent on yahoo.