[Forts]

I've seen a few users asking for direction on getting these radios up and running by hand on Fleetnet so here is a quick step thru:

- Hit PGM, then FUNC GLOB
- Scroll down to 138-174 5KHz... make sure its set to Yes, save the changes
- Now go PGM, NEW, TGRP
- Pick your scan list #
- TSYS - New, System type is MOT VHF/UHF
- Frequencies: Hit SEL then enter the Primary and Alternate control channels for the sites you want. Hit Save when done
- T Tables: Hit SEL, then SEL again to select Table 01
* For Table 01 enter: Lo Chan 380, Hi Chan 759, Offset 380, Base 141.0150, Step 15. Hit Save when done.
* For Table 02 enter: Lo Chan 380, Hi Chan 759, Offset 579, Base 151.7300, Step 15. Hit Save when done.
* For Table 03 enter: Lo Chan 380, Hi Chan 759, Offset 632, Base 154.3200, Step 15. Hit Save when done.

- Save all your changes, and start entering talkgroups (or just use a group wildcard to test your settings)

These basic settings should get you up and running. After confirming these settings work, then carry on and play with some of the other settings if you like (MultiSite, etc etc). I would recommend saving your working settings to a V-Scanner folder before messing around with the other options too much.

Perhaps an Admin can make this a sticky as well.