altonj
Member
2 NooElec SDR dongles - Unitrunker with one receiver parked on the CC of the Cayuga tower for Bell Fleetnet Zone 1 (Motorola Type II Smartzone with mixed analog and P25 voice) and one receiver set to follow voice comms. The voice receiver is set to send analog voice to the PC speakers and digital voice to Virtual Audio Cable where it is picked up by DSD+.
Each dongle has a WSM-1900 antenna sitting on a 30"x30" (approx) piece of sheet metal.
The CC receiver panels shows the 'Health' at either 98 or 100. Analog voice comes through very clear, decoded digital voice comes through at about 85-95% decode - I continue to play with levels, gain, etc to improve that.
5% to 10% of the time the voice comms receiver shows the transmission is "P1 FDMA" but it sends it to the PC speakers and not to DSD+. The other 90-95% of the time the digital voice is sent to DSD+ and is (mostly) decoded nicely. What am I doing wrong here?
Each dongle has a WSM-1900 antenna sitting on a 30"x30" (approx) piece of sheet metal.
The CC receiver panels shows the 'Health' at either 98 or 100. Analog voice comes through very clear, decoded digital voice comes through at about 85-95% decode - I continue to play with levels, gain, etc to improve that.
5% to 10% of the time the voice comms receiver shows the transmission is "P1 FDMA" but it sends it to the PC speakers and not to DSD+. The other 90-95% of the time the digital voice is sent to DSD+ and is (mostly) decoded nicely. What am I doing wrong here?
