putterizer
Member
Hoping I might get a few suggestions here on an issue I have.
I have an HT1250 that will transmit and receive fine on a simplex channel where the TX and RX are the same. This channel also has a PL tone on it.
The problem comes in when I try to transmit on a channel that is run through the county repeater with different TX, RX and PL tone. What is transmitted through the repeater is all static. When the PTT button is held and you listen to the TX channel from the repeater via a scanner, all that is heard is static. Dispatch is also not able to copy any transmission from this radio. No voice comes through at all. I have tried a couple of different of our county channels that are run through a repeater, and the same issue is happening on all the frequencies. As soon as the mic is keyed, its all static.
The HT1250 is programmed in with the same TX, RX, and PL tones as another one of my handheld radios which works fine. So I know it's not an issue with the TX, RX, or PL not being in the radio correctly.
Since our county uses repeaters and this radio does not work to TX on, its effectively turned into a scanner only.
Any ideas or help is appreciated.
Thanks.
I have an HT1250 that will transmit and receive fine on a simplex channel where the TX and RX are the same. This channel also has a PL tone on it.
The problem comes in when I try to transmit on a channel that is run through the county repeater with different TX, RX and PL tone. What is transmitted through the repeater is all static. When the PTT button is held and you listen to the TX channel from the repeater via a scanner, all that is heard is static. Dispatch is also not able to copy any transmission from this radio. No voice comes through at all. I have tried a couple of different of our county channels that are run through a repeater, and the same issue is happening on all the frequencies. As soon as the mic is keyed, its all static.
The HT1250 is programmed in with the same TX, RX, and PL tones as another one of my handheld radios which works fine. So I know it's not an issue with the TX, RX, or PL not being in the radio correctly.
Since our county uses repeaters and this radio does not work to TX on, its effectively turned into a scanner only.
Any ideas or help is appreciated.
Thanks.