Homepatrol-2 and Unitrunker

PLEASE HELP!

Homepatrol 2 (extreme upgrade) and Unitrunker (1.0.30.1).

Repeatedly try to set up UT, following instructions, with no success. It seems I am not getting raw data output from the HP. (No wave form on the scope). Have a CC freq. (Raw Data Output Screen : HP) from system that I am looking at. Start the UT program nothing happens. Checked serial port. ok, can use the VC on my ARC program. Any suggestions. Thanks.

Did you attempt to run with the receiver configured as a Home Patrol 1?

I don't know if the specs for talking to the HP-2E are different from the HP-1E.

Receiver Model drop down box HP-1 Only.

I've tried running my HP-2E with Unitrunker as well with no luck.

HP-2E and UT

The info from RR that I read,it seems HP-2E is compatible with UT. I am at a total lost. Maybe time to contact Uniden.

Buy a $15 R820T dongle. They work great with unitrunker and you can then listen to your scanner while unitrunker runs rather than waste a $580 scanner to feed unitrunker.

BCD536HP/HP2/996XT/PSR800/396XT/996T