ak4fn
Member
I made a video on how to set up dsd if you are on the fast lane, I hope this helps some people get it setup.
https://youtu.be/A2tpDhnuRHY
https://youtu.be/A2tpDhnuRHY
Some info:
FMP and DSD+ audio device numbers are "different" because FMP uses output devices and you were looking at DSD+ input devices (which is correct when linking to FMP/SDR#); in/out numbers can be different because you might have different devices, like an extra input or output device, which can shift all of the following devices numbers.
Also, if you make a device the default in or out device, it becomes in or out device #1 (IIRC), which again, shifts the other device numbers.
Network and site names have to be manually added to the DSDPlus.networks and DSDPlus.sites files. Systems do not broadcast these names.
When trunk voice following, the four FMP/DSD+ console windows ("DOS windows") do not provide much useful information; they can be minimized (by clicking minimize button in upper right corner of window)
Very good video. We should put you on the payroll.
Yes as long as you used 2 dongles (or scanner with tap and a dongle).
The first Dongle (or scanner w/tap) sits on the C/C channel with the audio being 'piped' into DSDplus decoding the control channel and it tells FMP which channel to tune the other dongle to (even if it is the same freq every time) and in the bat file for FMP we set a park freq for the dongle to sit at (stock config has it at 99.9) this audo gets 'piped' to DSDplus and it will decode the Voice.
So if the group is locked out it will never tell the Voice dongle to change from the parked frequency.
As far as the Slots go I have not played with that type of system but I did see someone say it is in the way you setup your DSDPlus.frequencies file. Here is the link
This is the system I am listening to, as you can see only one frequency.
Repeater Network (Schunnemunk LTR) Trunking System, Blooming Grove, New York - Scanner Frequencies
Note: NEXEDGE, Con+ and TIII (Hytera) trunking are fully supported
Cap+ trunking is less supported (no rest channel following)
IDAS trunking should work, but has not been tested
If the system truly has only one RF channel and you're getting voice on both timeslots, it's not a trunking system, so no, DSD+ will not let you monitor only certain groups.The system I am listening to has only one frequency .
There are several talk groups being heard (agencies)
Would what you show in the video allow me to monitor only certain groups ?
Also some trunk groups are coming in on slot 1
and some on slot 2 .
That is a PassPort system. If you are decoding DMR voice, that frequency is no longer used for PassPort.This is the system I am listening to, as you can see only one frequency.
Repeater Network (Schunnemunk LTR) Trunking System, Blooming Grove, New York - Scanner Frequencies