RS pro-668 question

I just received my pro-668 and it's running fine, I connected it to my computer and ran all the software then did the firmware up grades everything seems to be fine. I have a question though when i'm looking at the main configuration page on my computer and make changes they are not sent to the scanner and there is no button to send the new configuration, for instance I can change the scanner volume from the scanner but it doesn't change when I do it from the computer. I have tried everything I can think of. can someone answer how it's done?

Look at the top of the screen where it says scanner/sd card. In the drop down box it will say copy configuration to scanner memory/sd card. Click that and that will save your changes. I usually take the sd card out and put it in the computer to copy because it's a lot faster than copying to the card while in the scanner.

Thank you I'll give it a try my computer is smoking fast so it doesn't take long to do anything really.