How To Tell Unitrunker To Use A Saved EDACS System?

So I have Unitrunker running on a USB dongle and I have an EDACS system that I setup and saved in the Systems tab with all the frequencies and LCNs. Now when I start the dongle, how do I tell Unitrunker to use that saved EDACS system with all the LCNs already done instead of it starting a new unknown system with al 0.00000s for the LCNs?

The control channel has changed since the last session and I updated it in the receiver. Thanks.

Stop the receiver.
Delete the duplicate site / system.
Use the Pick Site tool to point the signal role VCO to the new control channel.

(You may have to check the pick site dialog option to include voice channels.)

Start the receiver.

The correct site window should appear.

Make sure Discover is un-checked.
You may also want to check "Chase" to follow the control channel the next time it rolls over.

Thanks. That Chase feature will be nice.

If you're listening to talk groups with a 2nd dongle, is there a way to set a delay so it will stay on the same talkgroup for like 5 - 10 seconds before it keeps jumping to other talkgroups? And, how can I permanently hold on a single talkgroup? Thanks.