Hello, I am looking for some input from the software experts in this forum. I am looking for a program that can decode P25 data on the input frequency. I have a HP1 (extreme upgrade) which allows the output of raw data. I connected this to Unitrunker, and when receiving the control channel output it decodes data. But when I enter the input, I do not get anything. Is there a program that would work in this fashion?
The purpose is for locating stolen and illegal radios on a trunking system. The optimum program would filter down by one or two radio IDs. Investigation involves driving around sending status check commands on the control channel (via net management terminal) while listening on the CC input for the radio to reply. The filter would be nice so the program would ignore all the radio IDs active on the control channel input, and just display the relevent radio IDs that are being searched out via status check replies.
We have commercial equipment that can accomplish this now, but I am looking for an option that would be a little more portable.
The purpose is for locating stolen and illegal radios on a trunking system. The optimum program would filter down by one or two radio IDs. Investigation involves driving around sending status check commands on the control channel (via net management terminal) while listening on the CC input for the radio to reply. The filter would be nice so the program would ignore all the radio IDs active on the control channel input, and just display the relevent radio IDs that are being searched out via status check replies.
We have commercial equipment that can accomplish this now, but I am looking for an option that would be a little more portable.