I just received a brand new WS1065 and programmed it up as I did with my previous GRE's. I set the scanner up on the same table as other scanners. Where the other scanners picked up local traffic perfectly, the WS1065 did not pick up any traffic. (Yes, I have the proper frequency and PL programmed and squelch set appropriately).
I took the scanner with me to work where we operate a 800 TRS P25 system and within eyesight of the tower, the scanner showed no signal strength (yes the proper control channels are programed) but as soon as I plug my other scanner into the antenna, it decodes fine.
I'm assuming I just received a bad unit out of the box. Has anyone else had any issues with reception/decoding right out of the box with any of these Whistler units?
I took the scanner with me to work where we operate a 800 TRS P25 system and within eyesight of the tower, the scanner showed no signal strength (yes the proper control channels are programed) but as soon as I plug my other scanner into the antenna, it decodes fine.
I'm assuming I just received a bad unit out of the box. Has anyone else had any issues with reception/decoding right out of the box with any of these Whistler units?