Wi-Fi Dongle Holder

Status
Not open for further replies.

rjdj2000

Gone Cuckoo
Feed Provider
Joined
Jan 24, 2011
Messages
347
Location
Central NY
Been trying to find something to hold the Wi-Fi dongle for awhile now and have gotten into the 3D printing area. So I designed this little holder that you can either screw into something or you can use double stick tape for it. If there would be any interest in it I can figure out what the cost would be on doing them.

IMG_1798.JPG


IMG_1799.JPG
 

KB6KGX

Completely Banned for the Greater Good
Banned
Joined
Nov 17, 2002
Messages
179
Location
Simi Valley, CA
Been trying to find something to hold the Wi-Fi dongle for awhile now and have gotten into the 3D printing area. So I designed this little holder that you can either screw into something or you can use double stick tape for it. If there would be any interest in it I can figure out what the cost would be on doing them.

That looks like one of those plastic mic holders? In MY car, I just shove the dongle in between the driver’s seat and the shift console. It’s out of the way, and works fine.
 
Status
Not open for further replies.
Top