rfjon
Member
Hi,
So here is a new user question about Unitrunker.
Configuration:
Unitrunker v1.0.32.7
DSD+ v1.101
SDRSharp v1.0.0.1581
VB Cable v1.0.3.5
DSDTune v0.1.3
RS Pro-106
NooElec SMArt
System: P25 Phase 1
Pro-106 set on Primary Control Frequency
NooElec SMArt set with one VCO on voice; Tuner gain set at 70
VB Cable Output Levels Set for Cable Output and Wave in Volume at "9"
The scanner works great and the Call History shows lots of reasonable entires
The VCO Scope and DSD+ VC Audio Source both show waveforms
DSD+ console shows event entries
The problem is either:
mostly no audio at all
occasional choppy robotic audio
DSDTune values of -f1 -ds60 -dv30 actually reduce the chance of hearing any audio at all.
I have twisted every knob that I could find out about by googling, but nothing makes it better.
SDRSharp shows that the NooElec SMArt is spot-on without any PPM Correction (checked on primary
control frequency 853.6125).
I would love to hear from anyone with specific experience/advise as to how to proceed.
Thanks, Jon
So here is a new user question about Unitrunker.
Configuration:
Unitrunker v1.0.32.7
DSD+ v1.101
SDRSharp v1.0.0.1581
VB Cable v1.0.3.5
DSDTune v0.1.3
RS Pro-106
NooElec SMArt
System: P25 Phase 1
Pro-106 set on Primary Control Frequency
NooElec SMArt set with one VCO on voice; Tuner gain set at 70
VB Cable Output Levels Set for Cable Output and Wave in Volume at "9"
The scanner works great and the Call History shows lots of reasonable entires
The VCO Scope and DSD+ VC Audio Source both show waveforms
DSD+ console shows event entries
The problem is either:
mostly no audio at all
occasional choppy robotic audio
DSDTune values of -f1 -ds60 -dv30 actually reduce the chance of hearing any audio at all.
I have twisted every knob that I could find out about by googling, but nothing makes it better.
SDRSharp shows that the NooElec SMArt is spot-on without any PPM Correction (checked on primary
control frequency 853.6125).
I would love to hear from anyone with specific experience/advise as to how to proceed.
Thanks, Jon