leopoldocosta
Newbie
- Joined
- Jun 14, 2018
- Messages
- 2
Greetings!
I'm maintaining a Motorola MTR3000 Base Station Repeater. I've tested it for with every single troubleshooting available in Motorola detailed and basic service manual. Finally what is left is that i recalibrate it providing a clock reference to its SCM board.
Anyway's, i've two service monitor: a HP 8920b and an IFR 1200s. As far as i know both generate signals, but only the 1200s is able to generate Motorola MTR3000 required signal wich is: 10Mhz with 3v peak-to-peak, sine or square wave.
I'm having some difficulty with this 1200s, trying to generate the signal. A helpful tip would be welcome. Is anyone here used to operate this service monitor?
I'm maintaining a Motorola MTR3000 Base Station Repeater. I've tested it for with every single troubleshooting available in Motorola detailed and basic service manual. Finally what is left is that i recalibrate it providing a clock reference to its SCM board.
Anyway's, i've two service monitor: a HP 8920b and an IFR 1200s. As far as i know both generate signals, but only the 1200s is able to generate Motorola MTR3000 required signal wich is: 10Mhz with 3v peak-to-peak, sine or square wave.
I'm having some difficulty with this 1200s, trying to generate the signal. A helpful tip would be welcome. Is anyone here used to operate this service monitor?