dcs code

I am able to read and write to my 7011 just fine but I am running into an issue with a channel I am programming which uses a 5MHz split. Here is the info on that: TX: 457.575 156N RX: 462.575 156N I have thoroughly checked over the information I am programming into the radio and its correct, the...

Hello - I have been detecting a continuous signal at exactly 462.000 MHz. While initially I thought this was GMRS, the GMRS channel plan starts at 462.5625 MHz, and does not appear to include 462 on the nose. I am able to pull DCS codes from the signal, however, they are non-standard codes...

I have purchased a Btech GMRS-V1 and am trying to get it to work with my cobra micro talk cxr900. I have set the frequency to 16 DCS 6 on the micro talk. The GMRS-V1 is setup with DCS 0043N for both TX and RX. When I key the micro talk up, it breaks the squelch on the GMRS-V1, but when I key...

Hi all, I'd like to share my experience with this tranceiver. Fisrt I wanted to have a cross band repeater for good price and it does the job nicely. I mainly using this tranceiver on UHF without any issues even if I think that the mic gain should be improved (you really have to talk close to...

I want to scan a system i have done in conventional analog. I want to set a DCS code so i can scan the system with the squelch wide open but only still hear the transmissions and no white noise. I have gotten something called “DCS Turn off” in the log a few times, but i wonder how i actually...