• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:

reset system

  1. F

    BCD436HP: Programing Favorites problem

    Yesterday I was programming the favorites fine. Today they will not program. I don't know if I changed a setting, or messed something else up. Now I go through the procedure on programming the favorites, and now takes longer to load the full data base than before, and after I load the data base...
  2. bionicworm1

    Resetting a BCD396t

    Hi All, After my firmware and software updates on my BCD396T I'm getting a lot of scanning in areas that I do not want. I'll set up one basic conventional system and in between it scans the Bandscope, all Custom freqs, Ham, CB, etc... Is there a full system reset I can do to just start...