• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:
    https://forums.radioreference.com/rants/224104-official-thread-live-audio-feeds-scanners-wait-encryption.html

trunkview

  1. R

    MPT-1327 decoding

    Hey gang, So I have been browsing around and I found some control and voice channels all in the MPT-1327 mode. I've tried to decode the control channel with Trunk View and no luck. Then, I told Trunk View to use 'stereo mix' and I went to the Sig ID wiki page and listened to an audio sample and...
  2. S

    Madison Oneida Co Schools MPT-1327 system

    Greetings, Our local school, Oneida City, Madison Co, NY (where I use to drive bus) has gone to a MPT-1327 Standard system. I have a GRE PSR 500 and 600 scanners, and not sure how to get frequencies from RR to my scanners. I am using the WIN500 program. Just wondering if anyone has...
  3. kd7rto

    Mapping the UP&L MPT-1327 Network

    I've been getting familiar with the Trunkview program, now it's doing a flawless job tracking UP&L with my IC-R8500. Many other radios are also supported, and it can be configured to follow MPT-1327 conversations in either a one radio or a two radio (control/voice) setup. One nice thing to...
  4. G

    Trunkview's compatibility with Realtek onboard audio

    Hi I'm trying to get Trunk view to work correctly. I have set the control channel and connected my BCD396T to the line in on my PC and the serial port. I can change channels fine with Trunkview and it is also decoding the control channel fine. But I cannot mute my input like the website says...
Top