• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:
    https://forums.radioreference.com/rants/224104-official-thread-live-audio-feeds-scanners-wait-encryption.html

996XT Auxiliary Audio Problem

Status
Not open for further replies.

mikebennett

Member
Joined
Nov 26, 2004
Messages
514
Location
Sherman, TX
I have a 996XT installed in the car and am feeding the external speaker audio out to a DPDT switch so that I can switch back and forth from the car audio system to the internal radio speaker. The wire run is probably less than a foot from the in/out of the radio through the switch. This set-up works great going through the car audio, however when it's directed back to the radio speaker I have to turn the volume up from the normal listening level of "6" to "16" or higher, and then it starts to get distorted. I'm guessing this has something to do with a mis-matched impedance from going through the switch.

Anyone have any ideas on how to fix this?

Mike
 
Status
Not open for further replies.
Top