• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Antenna placement on conversion van

Status
Not open for further replies.

gvocks

Member
Joined
Sep 17, 2010
Messages
2
Location
CENTRAL ILLINOIS USA
I have a big old conversion van (1990 Ford) that I want to mount a cb antenna on but I'm not sure what kind to get or where to put it. The van has a raised fiberglass roof so a magnet mount on top is not an option. The hood is metal but it's short and pretty much sloped. There is a built-in roof rack which consists of a couple of metal crossbars. There's a metal ladder mounted on the right rear door and a metal spare tire rack on the left rear door. The mirrors are extended-mount flat metal.

I'd really appreciate it if I could get some suggestions on what antenna to buy and where to mount it on this beast! BTW, with the raised roof and big tires I'm a bit over 8' tall. I don't want anything sticking up so far that I'm going to be taking down phone and cable TV wires when I drive through town. TIA
 

gvocks

Member
Joined
Sep 17, 2010
Messages
2
Location
CENTRAL ILLINOIS USA
Thanks for the reply! I know it says "fender mount" but do you have anything more specific? I'm primarily looking just to be able to talk with other people on the highway but as long as I'm going to do this I might as well do it the best way.

The top of the van is the only fiberglass--sides, fender, and hood are all metal. So I guess that there's enough metal that I don't need a "No ground plane" antenna?

Thanks, again, for any help!
 

freqs

Member
Joined
Jan 13, 2004
Messages
1,466
Location
warren michigan
Or you could go with a mag mount and place it on the hood iam not saying I would do it but have seen it done on trips not the best choice it will scratch .
emt8150 his idea is I would say your best bet you should not need extra ground for that but however if you go with the idea of a mount on the ladder it will need to be grounded those ladders dont have much of a ground
 
Status
Not open for further replies.
Top