I am using ARC XT Pro 1.5 Build 4. When the scanner stops on a channel that is using a DCS tone, the tone number is shown on my 396XT but is blank on the ARC XT Pro Virtual Control log. Why is this?
ARC XT Pro - Virtual Control - Subtone
- Thread starter PCTEK
- Start date
- Status
I have to verify this, we did make a change to the latest build 4 in the logger code for subtones.
Gommert
Butel Software
Gommert
Butel Software
Is the subtone programmed in a channel or is the scanner in subtone search mode?
If in search mode you need to enable 'log detected tones' on the Log Settings tab.
Gommert
Butel Software
If in search mode you need to enable 'log detected tones' on the Log Settings tab.
Gommert
Butel Software
- Status
