I have a question about my 996t. This scanner is still very new to me and I am trying to get used to the new bankless memory, so bare with me. It seems like it scans much slower than my BC785d did. One of the systems I have programmed is the UAMS TRS. It only has three freqs (855.9625, 855.4625, 854.9625) and two groups (Police, Maintenance). Each of these groups only has one channel with one talk group each, (Police-UAMS Police-TGID 1680) and (Maintenance-Maintenance-TGID 80). The Maintenance group is locked out. I have the Modulation set to Auto, the Attenuation set to Off, the Hold set to 0, and the C-Ch set to ON. There may be one TGID saved in the Quick Save but it is locked out. When scanning, it shows UAMS TRS along the top and S9 - - 3 - 5 - - - 9 - and GRP* - - - - - - - - - at the bottom of the screen.
When the scanner hits this system it takes approximately 4 seconds to scan through it. This would be the time it takes for UAMS TRS to appear on the screen until it disappears. I would think that it would scan through this system so fast that it would hardly be noticeable. Some of the larger sites I have programmed seem to scan quicker than this.
Please be gentle on me...like I said I am new to this scanner and I may very well have something entered wrong.
When the scanner hits this system it takes approximately 4 seconds to scan through it. This would be the time it takes for UAMS TRS to appear on the screen until it disappears. I would think that it would scan through this system so fast that it would hardly be noticeable. Some of the larger sites I have programmed seem to scan quicker than this.
Please be gentle on me...like I said I am new to this scanner and I may very well have something entered wrong.