deltaleader
Member
Need a little advice here, still very much new to this stuff. After researching a good antenna and cable suggestion. I am going with a 50ft LMR400 low loss cable from a OmniX antenna to my scanner. I realize this cable is quite stiff and will also need to run about a 10ft patch cable from the LMR400 to the scanner.
I am looking for a 10ft BNC Male to BNC Female patch cable. Was looking at the LMR 240 Ultra Flex cable for that based on my research.
Questions I have:
Does this setup sound reasonable?
Any other suggestions for a 10ft cable I should consider that is not going to mess my signal up?
Where are people buying these kind of cables? I cannot seem to find a reasonably priced site online.
I am looking for a 10ft BNC Male to BNC Female patch cable. Was looking at the LMR 240 Ultra Flex cable for that based on my research.
Questions I have:
Does this setup sound reasonable?
Any other suggestions for a 10ft cable I should consider that is not going to mess my signal up?
Where are people buying these kind of cables? I cannot seem to find a reasonably priced site online.