moonbounce
Member
- Joined
- Nov 5, 2002
- Messages
- 1,404
Anyone know how to calibrate SDR Sharp? For the life of me I can't get it to read the proper frequency that it lands on for example 142125000 will come out as 142125120 the next frequency will be 142365000 and it will show up as 142367988 or it will be 2.5 khz out. Also if I leave a freq. and go back to it later the readout will be different again, not at all consistent. I have tried to align the frequency by using the configure and frequency correction. It will set the correct frequency for one and throw it off for another. I can't seem to get it aligned.
I am using SDR Sharp version 1165 with the frequency manager + scanner. If I don't get a proper alignment of the bandwidth and the frequencies in that band, I can't use the scanner as it will not stop on any of the frequencies in that band as I can get the frequencies aligned.
Moonbounce
I am using SDR Sharp version 1165 with the frequency manager + scanner. If I don't get a proper alignment of the bandwidth and the frequencies in that band, I can't use the scanner as it will not stop on any of the frequencies in that band as I can get the frequencies aligned.
Moonbounce