Pro-106: Dispaly setting

[Lasernerd]

which setting do I put it at to get the display and pad only light when receiving? Stealth,Norm, etc?

 

[Swipesy]

which setting do I put it at to get the display and pad only light when receiving? Stealth,Norm, etc?

Set Light Mode to "Key" and Light Area to "Both".

 

[Weaksignal]

Perhaps you don't have the manual... Page 27 describes your question as well.

www.scancat.com/OnLineHelp/OEM_Radio_Owners_Manuals/PSR500-PRO-106_OwnersManual.pdf

 

[Lasernerd]

Thank you very much!

 

[Swipesy]

Perhaps you don't have the manual... Page 27 describes your question as well.

www.scancat.com/OnLineHelp/OEM_Radio_Owners_Manuals/PSR500-PRO-106_OwnersManual.pdf

Actually is does not. The manual is not clear as to setting the Light to "Key" does. It refers to key press. OP question asked for when there is a hit and one could easily assume you have to press a key. Your post was not necessary. I answered his question fully.

 

[Lasernerd]

OK,I did this change,Key on,set to both...my LED lights up Red on each hit but no pad or display Light?

 

[Swipesy]

OK,I did this change,Key on,set to both...my LED lights up Red on each hit but no pad or display Light?

Make sure your backlight is set to on for each Object. Setting look like this