• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:
    https://forums.radioreference.com/rants/224104-official-thread-live-audio-feeds-scanners-wait-encryption.html

Alinco: Dr-600 mr / mw button fuctioni

Status
Not open for further replies.
Joined
Jan 30, 2018
Messages
1
Location
Nashville, TN
#1
All function button work (they provide an acknowledgement tone) when pressed. Except the MR / MW button. Naturally I can't add into memory any freqs for VHF or UHF. Yes, CALL button beeps and I can enter freqs into both VHR and UHF call memorizes.

Buttons are touch rather than push / click on / push click off. Assume contacts on circuit board need cleaning or re soldering.

Any suggestions before I remove and dig into front panel?

What has been done:
Reset radio.
Replaced internal battery has been replaced.

Joe
N8MAL
 
Status
Not open for further replies.
Top