• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:

DSD+ 2.18 Trunk Voice Following problems

Not open for further replies.


Premium Subscriber
Jun 29, 2013
So, I recently got a new computer with Windows 7 Pro 64 bit, and I'm having some weird problems with DSD+ (Fastlane) 2.18 and FMP24. For some reason, I can't use the trunk voice following feature of FMP24 with 2 rtl dongles, which feature I've used for a long time on my old computer. AFAIK there are no error messages (and I've got my firewall disabled), but for some reason the voice following feature of FMP24 isn't working on a P-25 system.

Here are my startup commands along with screenshots of my setup:
{DSD+ CC} DSDPlus -i20010 -rc -Pmp3 -v4 -T -E -e -O NUL

{DSD+ VC} DSDPlus -i20011 -rv -Pmp3 -v4 -T -E -e -O NUL

[FMP CC] FMP24 -o20010 -P-0.5 -f856.0875 -rc -a0

[FMP Voice] FMP24 -i2 -o20011 -P-2.0 -rv -a0
Any suggestions would be greatly appreciated.


Not open for further replies.