Federal Signal Vision Lightbar Controller Question

Status
Not open for further replies.

ChevyGuyScott

Newbie
Joined
Oct 14, 2010
Messages
0
Does anyone know if theres a way to just use the controller as a switchbox / controller for other lights and such without having the gigantic V-bar mounted on the roof?

because I basically i just wanna use it for the Traffic advisor bar and the slide switch to control my other lights in sync, strobes, dash, grill lights etc.

Thanks
 

fineshot1

Member
Joined
Sep 17, 2004
Messages
2,532
Location
NJ USA (Republic of NJ)
I don't see why you could not do what you are asking.

I have done this with other light bar controllers and took out the
higher amp fuses and put in lower amp fuses for the lower current
consuming devices on the output ports to make it safer.
 

ChevyGuyScott

Newbie
Joined
Oct 14, 2010
Messages
0
well the reason I was asking is because someone told me that if the controller sensed a light was not connected or something it would cause an error and not work at all, and I don't even want the V-Bar hooked up. just want the TA bar and strobes and front and back lights grill etc.
 
Status
Not open for further replies.
Top