BlackSheepDue
Member
I will preface this with saying I know there are multiple threads on a similar topic and yes I have read through most but I am unable to find my actual situation. Most of the threads I have read are in reference to having to push to listen while monitoring trunking systems but I am having that issue on conventional QCII channels. My G5 has been working exactly as it should for the past few months until all of a sudden I noticed it didn't alert for a call. I have looked everywhere in my programming and the menu options on the pager with no luck. On selective call the pager does not alert unless I hold the push to listen button when the tones go out. On monitor I only get audio if I push to listen with one exception. If I switch my radio to talk around the pager unmutes when I key up but as soon as I go back to the repeater all I see is the signal bar but I get no audio. I have checked and my duty is set to on. I have reprogrammed the pager a few times, pulled the battery out, and reset to factory settings all to no avail. I will attach pictures from one of the channel settings but can provide more if needed. Apologies if this exact scenario has been covered but I don't think I changed anything to cause this and have been basically banging my head against the wall trying to figure it out.
