I have programmed in a local frequency for listen only. It's obviously a UHF frequency. It's a conventional setup with the xmit and rec freq being the same with no code. As basic as you can get.
The problem is at approximately every 8 to 10 seconds I get a signal that breaks squelch. Not long enough for data or voice. Similar to just bumping the xmit button.
I have set the squelch to 0 and everywhere in between to 255 and still have the same issue.
I get all radio traffic just fine.
I have the digital board installed but have no digital frequencies set up.
Any ideas what might be the issue?
The problem is at approximately every 8 to 10 seconds I get a signal that breaks squelch. Not long enough for data or voice. Similar to just bumping the xmit button.
I have set the squelch to 0 and everywhere in between to 255 and still have the same issue.
I get all radio traffic just fine.
I have the digital board installed but have no digital frequencies set up.
Any ideas what might be the issue?