Manual P25 adjustments don't stick

[Air490]

I am finding that I need to reset my manual P25 settings every time I turn the scanner on. Is this happening to other users?

 

[DSC45]

Yes, I'm experiencing the same thing.

 

[DSC45]

Hp2 Save P25 Changes

Is there a way to save changes made in the P25 menu for threshold and filter changes?

 

[kc5igh]

Is there a way to save changes made in the P25 menu for threshold and filter changes?

There doesn't seem to be. I started a string about this in the Uniden owner technical support section.

The instructions on pages 83 and 84 in the 325's manual are misleading, but I'm hoping that a firmware update will fix this issue.

Of course, it may take a while . . .

 

[W8RMH]

The HomePatrols and the XTs do the same thing. You have to set it every time you power up.

 

[Air490]

Well that's poo. I don't normally complain but I think Uniden need to fix this issue.

 

[RoninJoliet]

I do NOT have to reset the P25 settings every time I shut off my 996XT with the newest firmware 1.06.00....I adjusted the P25 adjust Mode to "8', and P25 Adjust Level to "50" and it stays there and decodes the Il-Starcom at 7-8 with "o" err rate...This is what should have been in the 325P2 model.....It shows "Auto" in test mode but it stays at "8"....