Pro-2044 Display Light Dead

[tglendye]

Does anyone know a part number or if I can get a replacement LED for my old 2044 display light? The scanner still works good, but I'd like to have the display light working.

Thanks
Todd

 

[mcema699]

Its just a bulb

Its not an LED, its an 8v lamp. You can try to order it.
Its cheaper to go into the store and get one. They're 6v not 8 but I've been using one in a PRO2052 for a while now.
In store part 12v 270-1141
6v 270-1140

If you order the exact part from them:
L001 10791416 LAMP,PILOT 8V 0.2A L0200

If you buy one in the store, cut the leads off the old one as close to the bulb as possible. The leads aren't very long.

 

[tglendye]

Thanks for the information. That helps!

 

[JESSERABBIT]

Is the display lamp on the Pro-96 and Pro-97 very difficult to remove and replace? Is it very accessable?

 

[SCPD]

this is how threads get twisted......

 

[n2mdk]

I just hate it when my thread gets twisted, makes it so hard to sew correctly.

 

[JESSERABBIT]

I thought as long as the thread was about lamps, it was appropriate. I apologize.

 

[tglendye]

I started this thread... no apologies needed on my behalf.

You might get a better response if you started a new thread w/ Pro96 & 97 in the subject, though. Since those are more popular & newer scanners more people would probably be able to answer this question.