• Effective immediately we will be deleting, without notice, any negative threads or posts that deal with the use of encryption and streaming of scanner audio.

    We've noticed a huge increase in rants and negative posts that revolve around agencies going to encryption due to the broadcasting of scanner audio on the internet. It's now worn out and continues to be the same recycled rants. These rants hijack the threads and derail the conversation. They no longer have a place anywhere on this forum other than in the designated threads in the Rants forum in the Tavern.

    If you violate these guidelines your post will be deleted without notice and an infraction will be issued. We are not against discussion of this issue. You just need to do it in the right place. For example:

Pro 2096 sub banks display

Not open for further replies.
Jan 14, 2007
While in scan mode.
The 3rd line indicates "T IDbk 01234"
I realize if hit Func - Trunk this will indicate the bank # and the Ch #
If I power off and on it will then show "T IDbk 01234" again.
I am familiar with what is happening with the sub bank being turned off and on but why isn't it consistent with
after a power cycle.

What am I doing wrong? It seems to do it in open and closed mode.

Not open for further replies.