I've been able to program three trunked radio systems in my new Unication G5 with relative ease.
I'm currently trying to program four conventional (non-trunked) channels (three are P25, and one is DMR), and I've run into problems I can't seem to untangle by myself.
I've entered the four frequencies in the "Conventional Frequency List" on tab 2 (Frequency and System Setting). When I move to the "Protocol Parameter Setting" tab and select "No Setting" under "Protocol Type", I receive a prompt telling me this protocol setting has been used in a previously programmed trunked system and advising me "If you want to delete, please cancel the bindings or remove the channel." I don't understand what that means.
If I select "P25 Conventional" under "Protocol Type", I get sent to tab four (Group ID setting), which contains all the TGID's I've entered for the three trunked radio systems mentioned above, minus the TGID numbers. Is this where I should enter a "Group Alias" for each of the four conventional channels I'm trying to enter? If so, does the "P25 Conventional" setting eliminate my ability to monitor the DMR channel?
I hope this is an understandable description of where I am right now.
Any advice will be appreciated!
Thanks!
I'm currently trying to program four conventional (non-trunked) channels (three are P25, and one is DMR), and I've run into problems I can't seem to untangle by myself.
I've entered the four frequencies in the "Conventional Frequency List" on tab 2 (Frequency and System Setting). When I move to the "Protocol Parameter Setting" tab and select "No Setting" under "Protocol Type", I receive a prompt telling me this protocol setting has been used in a previously programmed trunked system and advising me "If you want to delete, please cancel the bindings or remove the channel." I don't understand what that means.
If I select "P25 Conventional" under "Protocol Type", I get sent to tab four (Group ID setting), which contains all the TGID's I've entered for the three trunked radio systems mentioned above, minus the TGID numbers. Is this where I should enter a "Group Alias" for each of the four conventional channels I'm trying to enter? If so, does the "P25 Conventional" setting eliminate my ability to monitor the DMR channel?
I hope this is an understandable description of where I am right now.
Any advice will be appreciated!
Thanks!