Hi there !
I just start the adventure to program for the first time, one of my many Orion and M7100 radios
In a VHF model (D2HMCX), I want to copy the keypad I seen in one of our state police car.
They rotate the lower knob to change the channel (I.E. 1 = TX170.6550 MHZ RX 172.6550MHZ) and the left Up/Down buttons to change the channel guard (CTCSS). They assign a letter to each CTCSS (I.E. K=156.7 J=146.2) and also they use the center button, normally assign to the scan to enable the encryption. If the encryption is not active (or for any other reason that i don't know) they show a custom error message "Error 28, DISPATCH"
I can't figure out how I can assign the channel to the knob and the CTCSS to the button. Can somebody help me with that ?
Thanks
I just start the adventure to program for the first time, one of my many Orion and M7100 radios
In a VHF model (D2HMCX), I want to copy the keypad I seen in one of our state police car.
They rotate the lower knob to change the channel (I.E. 1 = TX170.6550 MHZ RX 172.6550MHZ) and the left Up/Down buttons to change the channel guard (CTCSS). They assign a letter to each CTCSS (I.E. K=156.7 J=146.2) and also they use the center button, normally assign to the scan to enable the encryption. If the encryption is not active (or for any other reason that i don't know) they show a custom error message "Error 28, DISPATCH"
I can't figure out how I can assign the channel to the knob and the CTCSS to the button. Can somebody help me with that ?
Thanks