sefrischling
Public Information Officer
I just adjusted a few TGs in a few zones in an 800 XTS3000 and now am having a scan issue.
Previously I created a scan list for every zone, Zone 1 matched scan 1, zone 2, scan 2, etc etc. If I changed a zone, and put the switch in scan, it scanned that zone only. I cannot figure out what i have changed, now no matter what zone I am in, when in scan the radio only scans zone 1, along with whatever single channel I am on the in zone I am in.
If I am in zone 7, I want to scan zone 7, not Channel 3 in zone 7, and everything in zone 1. Previously if I was on channel 3 in zone 7 and in scan, it only scanned zone 7. Or did I mess something up that it now only scans Scanlist 1 , programmed from the CPS?
Suggestions on what I have missed in trying to correct this issue? There are both trunked and conventional in each zone, but there have always been a mix of trunked and conventional in the zones.
I have been using the Astro Saber/XTS 3000 radios for quite a while, so I am not new to CPS or the radios by any means, but I just cannot figure out what I botched while making a simple channel change in certain zones.
Thanks
Previously I created a scan list for every zone, Zone 1 matched scan 1, zone 2, scan 2, etc etc. If I changed a zone, and put the switch in scan, it scanned that zone only. I cannot figure out what i have changed, now no matter what zone I am in, when in scan the radio only scans zone 1, along with whatever single channel I am on the in zone I am in.
If I am in zone 7, I want to scan zone 7, not Channel 3 in zone 7, and everything in zone 1. Previously if I was on channel 3 in zone 7 and in scan, it only scanned zone 7. Or did I mess something up that it now only scans Scanlist 1 , programmed from the CPS?
Suggestions on what I have missed in trying to correct this issue? There are both trunked and conventional in each zone, but there have always been a mix of trunked and conventional in the zones.
I have been using the Astro Saber/XTS 3000 radios for quite a while, so I am not new to CPS or the radios by any means, but I just cannot figure out what I botched while making a simple channel change in certain zones.
Thanks