Hi Guys,
Is there a way to specify a control channel to be used when scanning a trunked system? My scanner keeps switching between the control channel I would like it to use (site near to me with very good reception) to another control channel for a site further away which means I get a bad signal. Is there any way to stop this from happening so that my scanner will just use the one control channel always?
Any help I can get would be greatly appreciated.
Thanks.
Is there a way to specify a control channel to be used when scanning a trunked system? My scanner keeps switching between the control channel I would like it to use (site near to me with very good reception) to another control channel for a site further away which means I get a bad signal. Is there any way to stop this from happening so that my scanner will just use the one control channel always?
Any help I can get would be greatly appreciated.
Thanks.