Setting control channel on UBCD396T

[panrid67]

Hi Guys,

Is there a way to specify a control channel to be used when scanning a trunked system? My scanner keeps switching between the control channel I would like it to use (site near to me with very good reception) to another control channel for a site further away which means I get a bad signal. Is there any way to stop this from happening so that my scanner will just use the one control channel always?

Any help I can get would be greatly appreciated.

Thanks.

 

[W8RMH]

Remove the other control channel. The 396T does not do multiple sites. You need to setup a system for each site.

 

[marksmith]

The system will change control channel as it is programmed to do periodically. If you delete it you will get nothing.

On the other hand, if it is a different site, creating separate sites will work.

Sent from my LG-V410 using Tapatalk