uniden bcd996xt problem

[sameehosen]

During the process two uniden bcd996xt Reload been cut power to lift off the machine and no longer only a blue screen
I tried again and update it has been a long process and eventually failed modernization process and device remained the same blue screen and no takeoffs Q: Will I have a solution to this problem?

 

[Voyager]

Just to clarify, while updating the firmware you cut the power despite the warning not to do that?

Two options:

1. Try the update again.

2. Send to Uniden for repair.

 

[sameehosen]

Thanks for the reply

Thanks for the reply
Disconnect the power supply was a technical hitch
Tried to update a second time and a third was the most successful
Starts writing on the device at the end of the update gives me this message

 

[Ronaldski]

Are you using the BC VUP 3 Revision 01 updater program? When I run my bc vup 3 I get the same pop up error minus being hooked up to the radio.

Mine shows in the header part of the program underneath the error window ...
BC VUP Version 3.00 (revision 01) - Firmware update loader -

Since I recreated the same without using the cable, I'm thinking maybe your cable has a problem? I had one before that went bad on me as well.

 

[sameehosen]

Thank you my friend to respond
I'll try to change the cable and the experiment again and I'll tell you the result
Thank you for the message

 

[sameehosen]

Thank you my friends
I especially thank Mr. Ronaldski
Device returned to work by simply changing the programming cable
Thank you

 

[Ronaldski]

Dang "He" is good isn't he ! LOL

Glad it worked out!

 

[sameehosen]

My friend
A new problem emerged
No longer stand the scanner during the process of searching for channels Automatically