Yupiteru MVT-7100 reception problem

Status
Not open for further replies.

gscottm

Newbie
Joined
Aug 31, 2011
Messages
2
Location
Maine
Hello,

I recently purchased a Yupiteru MVT-7100 scanner. I was listening to a local FM station a few days ago. The reception was fine.

I got up from my desk and grabbed the scanner. I seem to have inadvertently pressed a few of the buttons on its front. Next thing I knew, the reception for that local FM and other stations became very spotty. I had to turn up the squelch, but the scanner was sounding like was a few hertz off.

Not knowing what else to do, I installed new batteries and reset the receiver. It reset to 144.000. After tuning to any FM station, it still sounds the same: crackling and sounding unintelligible.

Can anyone tell me how to go about fixing this problem?
 

gscottm

Newbie
Joined
Aug 31, 2011
Messages
2
Location
Maine
Fixed

Thank you both for your help. It turns out it was the receive mode. Didn't know how to change it, but I learned. Thanks.
 
Status
Not open for further replies.
Top