clearing preprogrammed systems

[mbhelect]

i recently purchased a bcd996t.
I would like to clear out all the preprogrammed systems.
Is there anyway i can do this easily instead of going to each system?

Thanks

Bill

[cpuerror]

Turn it on while holding 2+9+Hold. It will erase everything from memory.

If anyone else attempts to do this, beware there is no Are You Sure prompt.

[Smerri]

I don't know if you can clear them, but are you aware you can shut them off?

I know on my BCT15 (I think your 996 has the same buttons) you can press POL and HP until the letters disappear off the screen.

*Nevermind* - Your question was answered prior to my post.

[mbhelect]

Thanks cpuerror that did it.
I knew it had to be something simple but couldn't for the life of me figure it out.

Bill

[torontokris]

note that hold + 2 + 9 will delete EVERYTHING from your scanner not just the pre-programmed ones

so if you have added anything back it up

[Viper43]

asked and also answered on the 396T yahoo group......

V