View Single Post
  #8 (permalink)  
Old 11-19-2017, 7:58 PM
jim202 jim202 is offline
Member
   
Join Date: Mar 2002
Location: New Orleans region
Posts: 2,496
Default

I would not choose the original panel feed through connectors that you showed a picture of in the first message. That is way too much work to mount them. I would suggest that you get the panel feed through connectors that are threaded and use the nut that comes with them to mount them.

This way if you make your own panels, all you have to do is drill a hole to allow them to be fed into the panel and then just tighten them up. Much less work to construct the panels.

The choice is yours on to buy or to build to suit your location. With the connectors mounted to your panels, you can put the surge protectors right on the panels and then just ground the panels.

Good luck on your endeavor Take a photo of the panels installed so the group can see the finished results.
__________________
Jim
Reply With Quote