hello everyone!!
I recently purchased a Rascal Mk IV to try and setup my own echolink node....I was suggested to go this route but im having trouble getting it to work with the echolink software....what im not sure is this device does not use a serial output to control the PTT on the radio it says it incorporates a automatic ptt circuit that eliminates the need for usb or serial but what i cant figure out is what do i set for the RX and TX control in the echolink software....any help with this would be great...im using a kenwood 261 to interface with the rascal.
I recently purchased a Rascal Mk IV to try and setup my own echolink node....I was suggested to go this route but im having trouble getting it to work with the echolink software....what im not sure is this device does not use a serial output to control the PTT on the radio it says it incorporates a automatic ptt circuit that eliminates the need for usb or serial but what i cant figure out is what do i set for the RX and TX control in the echolink software....any help with this would be great...im using a kenwood 261 to interface with the rascal.
