TrenchFeeder
Member
I know you guys are probly getting sick of my problems, but I'm not getting a control tone on the Will Co. EDACS. I rechecked the frequencies all programmed in correctly.
I'm leaning towards it being a problem with my scanner, because when i hit the manual button it goes to bank 0 channels, and I have the EDACS programmed in bank 1. Usually when I hit manual while I'm scanning the EDACS it drops into bank 1 on the control tone.
I just wanted to put it out there and see if anyone else was having the same issue, before I run out and buy a new scanner
I'm leaning towards it being a problem with my scanner, because when i hit the manual button it goes to bank 0 channels, and I have the EDACS programmed in bank 1. Usually when I hit manual while I'm scanning the EDACS it drops into bank 1 on the control tone.
I just wanted to put it out there and see if anyone else was having the same issue, before I run out and buy a new scanner