cdesigns
Member
Since there is no specific forum for Maxon Radios Im asking here.
After learning that my old PCs were to fast to run my Maxon Dos software I was able to find a 91mhz laptop that now detects my programing cable and detects my radio, BUT Im unable to read my radio.
This is what I have:
1) Maxon SMP4004C Software (bought legally)
2) Maxon Programming Cable
3) Maxon SP-120 UHF Radio
The software detects the programming cable "chip" and detects the radio when its on and off, but it doesnt reads the radio.
I follow the instructions on the first picture and then I go to the second picture where Im stuck (RED light is on) and it ask to push the MONITOR button to start and nothing happens, if I turn off the radio the software goes back to the main menu.
After learning that my old PCs were to fast to run my Maxon Dos software I was able to find a 91mhz laptop that now detects my programing cable and detects my radio, BUT Im unable to read my radio.
This is what I have:
1) Maxon SMP4004C Software (bought legally)
2) Maxon Programming Cable
3) Maxon SP-120 UHF Radio
The software detects the programming cable "chip" and detects the radio when its on and off, but it doesnt reads the radio.
I follow the instructions on the first picture and then I go to the second picture where Im stuck (RED light is on) and it ask to push the MONITOR button to start and nothing happens, if I turn off the radio the software goes back to the main menu.