Guillaumet
Newbie
Hello
I have three Kenwood NX-320 Man-Down and a NX-820.
In case of a man-down, the NX-820 rings, displays a text like: M.Dwn ID=10, and the Horn output is switched on the accessory connector.
I need to replace the (stolen) NX-820 for a NX-3820. But the programmation is very different. I have some difficulties. My prog. is OK for the voice but not for the man-down.
Can someone give me some tips for programming the man-down section of my NX-3820 ?
(sorry for my bad english)
Many Thanks
Guillaumet
I have three Kenwood NX-320 Man-Down and a NX-820.
In case of a man-down, the NX-820 rings, displays a text like: M.Dwn ID=10, and the Horn output is switched on the accessory connector.
I need to replace the (stolen) NX-820 for a NX-3820. But the programmation is very different. I have some difficulties. My prog. is OK for the voice but not for the man-down.
Can someone give me some tips for programming the man-down section of my NX-3820 ?
(sorry for my bad english)
Many Thanks
Guillaumet