• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

Programming issue kenwood NX-700k

Status
Not open for further replies.
G

gspivey

Member
Joined
Feb 18, 2003
Messages
49
Location
North carolina
Hi, I'm trying to program the above radio with firmware 4.73 and an ftdi cable with latest drivers and kpg143d software version 5.10. I can get it to read the transceiver information from the radio, but that's all. When I try reading or writing programming I get the error code to check the model number, market code, and display type, all of which seem to be correct. Do I need a different version of the software? Thanks for any help!
 
Status
Not open for further replies.

Similar threads

Baker845
Kenwood Nx-5200 MDC settings
Replies
11
Views
498
Baker845
Baker845
kb1ejw
NX-5800 mic question
Replies
2
Views
189
kb1ejw
kb1ejw
F
Question about KPG-D3N programming for NX-3320.
Replies
2
Views
523
FoxtrotActual
F
A
Dual Capacity Direct Mode/CC15
Replies
4
Views
468
wd8chl
W
Baker845
APX-6000 question
Replies
3
Views
468
Baker845
Baker845
Top