Hello all,
I have searched this forum several times for an answer to this question and have been unable to find it. If I have simply missed it, I apologize. I have a MaxTrac 300 VHF radio that I purchased from eBay. It is model # D43MJA77A3BK. It was a six-channel radio, without scan but with tone decoding/encoding and TPL/DPL. I have successfully modified the MAXTRAC.MDF file in the RSS to increase it to 16 channels, and have also enabled the RSS to modify the modes' scan lists. The radio, however, will not scan. The front panel has an "Exit" button in place of the "Scan" button, and when I press it, nothing happens. Is there a way to modify the codeplug to reprogram that button to become a scan button? I do not have access to Lab software to just blank the board and reinitialize it as a different model, nor do I know anyone who does. It was my understanding from the batlabs and repeater-builder websites that it is possible to do this, but perhaps I am mistaken. I have version R07.02.00a of the RSS, and the radio has the v 5.34 firmware and 16-pin logic board, so I am absolutely certain that it is capable of scanning. I also have Hex Workshop, which is how I modified the .mdf file. Any assistance would be greatly appreciated.
Craig Nicholson
spanishfreak88@yahoo.com
I have searched this forum several times for an answer to this question and have been unable to find it. If I have simply missed it, I apologize. I have a MaxTrac 300 VHF radio that I purchased from eBay. It is model # D43MJA77A3BK. It was a six-channel radio, without scan but with tone decoding/encoding and TPL/DPL. I have successfully modified the MAXTRAC.MDF file in the RSS to increase it to 16 channels, and have also enabled the RSS to modify the modes' scan lists. The radio, however, will not scan. The front panel has an "Exit" button in place of the "Scan" button, and when I press it, nothing happens. Is there a way to modify the codeplug to reprogram that button to become a scan button? I do not have access to Lab software to just blank the board and reinitialize it as a different model, nor do I know anyone who does. It was my understanding from the batlabs and repeater-builder websites that it is possible to do this, but perhaps I am mistaken. I have version R07.02.00a of the RSS, and the radio has the v 5.34 firmware and 16-pin logic board, so I am absolutely certain that it is capable of scanning. I also have Hex Workshop, which is how I modified the .mdf file. Any assistance would be greatly appreciated.
Craig Nicholson
spanishfreak88@yahoo.com