Mounting a Wellbrook

Status
Not open for further replies.

mbott

Member
Premium Subscriber
Joined
Oct 11, 2015
Messages
707
Location
EN80nd
Came across this pic and I thought I would share it here. I have used this to mount my Wellbrook on a rotor and it seems to provide plenty of support.

--
Mike
 

Attachments

  • Wellbrook Mount2.jpg
    Wellbrook Mount2.jpg
    63.7 KB · Views: 593

EricCottrell

Member
Premium Subscriber
Joined
Nov 8, 2002
Messages
2,413
Location
Boston, Ma
Hello,

Thanks for posting. I bought the adapter and then it was off to Home Depot for PVC hardware. I am using a speaker stand, so I bought a 1/2" x 3/4" reducing male adapter, a 3/4" coupling, and 3/4 inch pipe. The PVC adapter and coupling fits in the tube of the speaker stand. The pipe is used as a spacer. The "nut" on the PVC adapter prevents the assembly going completely into the tube. I am going to drill a hole through the coupling that lines up with existing holes in the tube and put a bolt through to hold it.

73 Eric
 

EricCottrell

Member
Premium Subscriber
Joined
Nov 8, 2002
Messages
2,413
Location
Boston, Ma
Hello,

Here are a couple of pictures. I ended up wrapping some duct tape around the pvc for a snug fit in the tube so the loop will not move in the wind. It worked well.

73 Eric
 

Attachments

  • 2017MtlAnt1.JPG
    2017MtlAnt1.JPG
    194.6 KB · Views: 307
  • 2017MtlAnt2.JPG
    2017MtlAnt2.JPG
    134 KB · Views: 415
Status
Not open for further replies.
Top