Search results

All Forests have been assigned a tone for their output since the 70's. It is just many don't use them. Additions to your list that I know off the top of my head are the Angeles and Los Padres, both 103.5.

Which VHF freq have they been using?

It may have something to do with the internal investigation that has been going on thats really no secret with one in the Fresno County jail now

Make sure the mobile is not in any scan mode before you attempt to conect to it to download or upload.

E3 is VCO out of lock

The FCC data base shows 3 licenses to the state of Nebraska for the state wide trunking system so I am sure that is what you heard. I did not take the time to research where the 3 sites are.

The radio that says fail to connect is probably a different firmware version. Compare it with the one you were able to program. If it is a higher version you will need to use the newer programing software, if it is a lower version number use the older software. They are all on the same site you...

Do the talkgroups match? One program have talkgroups set to Hex and the other decimal? Lots of a places to mess up programing in P25.

Thanks for whatever you did, it works now

I just returned home and one of my feeds, Madera County Sheriff, CHP for Madera, Mariposa, and Merced Counties Live Scanner Audio Feed has been down for a few days. It shows connected from the feed point but shows off line when you look at it. I have rebooted the computor and reconected with the...

Sierra Forest is 171.475, 172.225 plus all the national commons such as tacs 168.050, 168.200, 168.700 air guard 168.625 flight follow 168.65 and on plus a few UHF links

Leaky cable TV can do this

I am looking for MX 300 series modules to convert a low split radio (400 -430) to 460 or inexpensive MX radios in that range. Please PM me. Will trade modules if you need low split. Thanks Frank

I listen to them and stream it, I dont have any issues with that frequency.

Can anyone help me. I am trying to program a VX4000 to 440 but the software won't accept anything below 450.

I could also be Lemoore NAS

When you get past the ch select paramater, scroll to TX tone type and change it from ccs to dcs then do the same to rx tone type and save them. Then scroll through the tone selections. It is easier with the pc software though but can be done by user programing. Frank

Can you user program the radio? If so go to ch programing, rx or tx tone type and select edit then dcs. If you can and can't figure it out, PM me and I will provide a phone number for you to call me and I will walk you through it.

I should have meationed, the command zone allows you to add channels from any zone to it and they go in in the order you add them. You delete them from the comand zone same as you add them. It allows a user on an incedent to build a zone on the fly from what is in the radio without haveing to...

The DCS codes are at the very bottom of the ctcss codes. scroll all the way down the list. Also they are listed as the code slash the inverted. The command zone is zone 0. The PC software is available along with the cables.