Here is my attempt...
I used radio mounts and lighting panels that fit a standard Jotto desk. I used rack rails from Guitar Center as the side supports.
All I did to install was carefully pull the vertical silver accents away from the dash and remove the 4 screws from the lower storage box.
To mount the rails I bought 2.5in corner braces and cut 1 side down to 1.5in and redrilled a hole.
I then used the top screw holes in the dash from the plastic box I removed to secure to the dash.
To run the wires, I used the large round firewall grommet on the passenger side of the truck.
At the top of the grommet is a rubber bubble if you cut the bubble it gives you an easy access for the wires to pass through.
This grommet gives you easy access to the aux fuse panel on the passenger side kick panel.
Any questions email me...
Chris
I used radio mounts and lighting panels that fit a standard Jotto desk. I used rack rails from Guitar Center as the side supports.
All I did to install was carefully pull the vertical silver accents away from the dash and remove the 4 screws from the lower storage box.
To mount the rails I bought 2.5in corner braces and cut 1 side down to 1.5in and redrilled a hole.
I then used the top screw holes in the dash from the plastic box I removed to secure to the dash.
To run the wires, I used the large round firewall grommet on the passenger side of the truck.
At the top of the grommet is a rubber bubble if you cut the bubble it gives you an easy access for the wires to pass through.
This grommet gives you easy access to the aux fuse panel on the passenger side kick panel.
Any questions email me...
Chris