So clean, wish my 17 SIlverado had that upgraded console. I've looked to see what it would take to add the upgraded console to the LT, it is a lot. Hopefully I can start finding some LTZ and GMC consoles in the junk yards soon.
I have seen those and will probably end up going that route at some point. It will block the door on the bottom of the dash... of course the upgraded console would as well. I think it's hard to beat what BryceT has done as far as a getting a clean and accessible install spot. That small console seems like it puts everything too close to the floor/trans tunnel.Havis makes a nice console that fits below the dash in front of the 40/20/40 console like most of the LTs come with. Works well.
I have seen those and will probably end up going that route at some point. It will block the door on the bottom of the dash... of course the upgraded console would as well. I think it's hard to beat what BryceT has done as far as a getting a clean and accessible install spot. That small console seems like it puts everything too close to the floor/trans tunnel.
Yeah it was a concern, after looking at Havis pics again, doesn't look as bad as I thought. For some reason I thought the box was shorter. Don't mean to hijack the thread.
I believe i saw on another forum or site it was a rockland unit. I requested a quote as i have one i am trying to install like that. My issue has been the power cables to the engine compartment. Like to know how they routed them in this one.
I went through the rubber grommet/boot that is on the driver side - easier to see it from the engine compartment than from under the dash. It is a common pass-through. You'll have to cut a hole, though, on both sides and fish something through. I used a coat hanger and then tied on the wire(s). Then it's just across the firewall or whatever. Power post over by the battery.
Thanks. That what everyone say. I can't see the boot inside or out. This is a loaded Denali with a Duramax. I can barely see the boot inside but can't see it at all outside.
I've found quite a few in junkyards (<$500 including s/h), still in great shape, been thinking about replacing the one in my '18 for one out of a '14-'15, cupholder moves, so I can put the radios in the deep pocket in the rear of the console.So clean, wish my 17 SIlverado had that upgraded console. I've looked to see what it would take to add the upgraded console to the LT, it is a lot. Hopefully I can start finding some LTZ and GMC consoles in the junk yards soon.
I'm looking at maybe giving up on the before mentioned idea and going with a Rockland Custom, but I'm not sure if my Uniden PC122XL will fit down in enough to be at the same level with my scanner. Otherwise, it's both plans.Was that console drop in from Rockland Custom Cabinets? I can't seem to get to the website right now. I have a 2015 Sierra with that style console and need to install some radios.